Control Strategy for Power Sharing in Input-Parallel and Output-Parallel Connected DC-DC Converters

Document Type : Research Article

Authors

Department of Electrical Engineering, Faculty of Energy, University of Technology, Kermanshah, Iran

Abstract

Input-Parallel Output-Parallel DC-DC converters are convenient for high voltage and high current applications. One important goal of this type connection is to power-share and reduce circulating current between the converters. Therefore, control methods for power-sharing between converters should be used when the parameters mismatch. In this paper, a configuration comprising two DC-DC common grounded Z-source converters with Input-Parallel Output-Parallel connections is presented, which common grounded Z-source converter have advantages over similar converters. This study proposes two control strategies: (1) a decentralized inverse-droop control, (2) a general control strategy. Inverse-droop control is a simple method and does not need any communication between parallel converters. In the general control strategy, each converter is self-contained, and no external controller is required for achieving input/ Output Current Sharing, and a few wires are needed to create the entire system. The simulation results of an Input-Parallel Output-Parallel system comprising two common grounded Z-source converters are evaluated for investigating effectiveness of general control and inverse-droop control. It reported performance of the general control method to be better than the decentralized inverse-droop control method, which enhances the stability and dynamic characteristics of the system. The validity of the two control strategies has been studied through MATLAB simulation and the results were satisfactory.

Keywords

Main Subjects


[1] E. Rokrok, F. Shavakhi Zavareh, J. Soltani, M. Shakarami, “A Robust Control Strategy for Distributed Generations in Islanded Microgrids”, in AUT Journal of Electrical Engineering, 52(1) (2020),107-120. DOI: 10.22060/ eej.2019.14901.5246.
[2] S. Augustine, M. K. Mishra and N. Lakshminarasamma, “Adaptive Droop Control Strategy for Load Sharing and Circulating Current Minimization in Low-Voltage Standalone DC Microgrid,” in IEEE Transactions on Sustainable Energy, 6 (2015 (132-141. doi: 10.1109/ TSTE.2014.2360628.
[3] M. Rahideh, A. Halvaei Niasar, A. Ketabi, I. zamani, Linear Quadratic Integral optimal control of photovoltaic systems, AUT Journal of Electrical Engineering, 52(2) (2020) 231-242. DOI: 10.22060/eej.2020.14970.5249.
[4] E. Jafari, Determining the Optimal Strategy of Multi Virtual Power Plants using GA-GT, AUT Journal of Electrical Engineering, 52(2) (2020) 243-254. DOI: 10.22060/eej.2020.17607.5322.
[5] G. Xu, D. Sha and X. Liao, “Decentralized Inverse[1]Droop Control for Input-Series–Output-Parallel DC–DC Converters,” in IEEE Transactions on Power Electronics, 30 (2015) 4621-4625. doi: 10.1109/TPEL.2015.2396898.
[6] J. Shi, L. Zhou and X. He, “Common-Duty-Ratio Control of Input-Parallel Output-Parallel (IPOP) Connected DC–DC Converter Modules with Automatic Sharing of Currents,” in IEEE Transactions on Power Electronics, 27 (2012) 3277-3291. doi: 10.1109/TPEL.2011.2180541.
[7] Ravi Kumar Gupta, Vishnu Mohan Mishra, N.K. Singh, “Elimination of circulating current in parallel operation of single-phase inverter using droop controller”, Engineering Science and Technology, an International Journal, (2021). https://doi.org/10.1016/j. jestch.2021.06.005.
[8] S. Augustine, N. Lakshminarasamma and M. K. Mishra, “Control of photovoltaic-based low-voltage dc microgrid system for power sharing with modified droop algorithm,” in IET Power Electronics, 9 (2016) 1132- 1143. doi: 10.1049/iet-pel.2015.0325.
[9] S. Anand, B.G. Fernandes, J. Guerrero, Distributed control to ensure proportional load sharing and improve voltage regulation in low-voltage dc microgrids, IEEE Trans. Power Electron. 28 (4) (2013) 1900 1913, https:// doi.org/10.1109/TPEL.2012.2215055.
[10] J. Beerten, R. Belmans, Analysis of power sharing and voltage deviations in droop-controlled dc grids, IEEE Trans. Power Syst. 28 (4) (2013) 4588–4597, https://doi. org/10.1109/TPWRS.2013.2272494.
[11] D. Sha, Z. Guo, T. Luo and X. Liao, “A General Control Strategy for Input-Series–Output-Series Modular DC–DC Converters,” in IEEE Transactions on Power Electronics, 29 (2014) 3766-3775. doi: 10.1109/ TPEL.2013.2278546.
[12] X. Ruan, W. Chen, L. Cheng, C. K. Tse, H. Yan and T. Zhang, “Control Strategy for Input-Series–Output[1]Parallel Converters,” in IEEE Transactions on Industrial Electronics, 56 (2009) 1174-1185. doi: 10.1109/ TIE.2008.2007980.
[13] M. Abrehdari and M. Sarvi, “Comprehensive sharing control strategy for Input-Series Output-Parallel connected modular DC–DC converters,” in IET Power Electronics, 12 (2019) 3105-3117. doi: 10.1049/iet[1]pel.2019.0054.
[14] D. Liu, F. Deng, Z. Gong and Z. Chen, “ Input-Parallel Output-Parallel Three-Level DC/DC Converters with Interleaving Control Strategy for Minimizing and Balancing Capacitor Ripple Currents,” in IEEE Journal of Emerging and Selected Topics in Power Electronics, 5 (2017) 1122-1132. doi: 10.1109/JESTPE.2017.2649221.
[15] W. Chen, G. Wang, X. Ruan, W. Jiang and W. Gu, “Wireless Input-Voltage-Sharing Control Strategy for Input-Series Output-Parallel (ISOP) System Based on Positive Output-Voltage Gradient Method,” in IEEE Transactions on Industrial Electronics, 61 (2014) 6022- 6030. doi: 10.1109/TIE.2014.2308147.
[16] Chin-Hsing Cheng, Po-Jen Cheng, Ming-Jia Xie, “Current sharing of paralleled DC–DC converters using GA-based PID controllers, “in Expert Systems with Applications, 37 (2010) 733-740.
[17] W. Chen and G. Wang, “Decentralized Voltage-Sharing Control Strategy for Fully Modular Input-Series–Output[1]Series System with Improved Voltage Regulation,” in IEEE Transactions on Industrial Electronics, 62 (2015) 2777-2787. doi: 10.1109/TIE.2014.2365433.
[18] S. Rostami, V. Abbasi and F. Blaabjerg, “Implementation of a common grounded Z-source DC–DC converter with improved operation factors,” in IET Power Electronics, 12 (2019) 2245-2255. doi: 10.1049/iet-pel.2018.6044.
[19] M. Rezaie and V. Abbasi, “Effective combination of quadratic boost converter with voltage multiplier cell to increase voltage gain,” in IET Power Electronics, 13 (2020) 2322-2333. doi: 10.1049/iet-pel.2019.1070.
[20] J Barnabas Paul Glady, K Manjunath, “Analysis[1]intelligent design and simulation of improved state–space modelling for control of Luo converter,” in Computers & Electrical Engineering, 75 (2019) 230-244.
[21]  R. R. Ahrabi, H. Ardi, M. Elmi and A. Ajami, “A Novel Step-Up Multiinput DC–DC Converter for Hybrid Electric Vehicles Application,” in IEEE Transactions on Power Electronics, 32 (2017) 3549-3561. doi: 10.1109/ TPEL.2016.2585044.
[22] Nanfang Yang, Damien Paire, Fei Gao, Abdellatif Miraoui, Weiguo Liu, “Compensation of droop control using common load condition in DC microgrids to improve voltage regulation and load sharing”, in International Journal of Electrical Power & Energy Systems, 64 (2015) 752-760.
[23] L. Shu, W. Chen and X. Jiang, “Decentralized Control for Fully Modular Input-Series Output-Parallel (ISOP) Inverter System Based on the Active Power Inverse-Droop Method,” in IEEE Transactions on Power Electronics, 33 (2018) 7521-7530. doi: 10.1109/TPEL.2017.2773559.
[24] Arshad Nawaz, Jing Wu, Chengnian Long, “Mitigation of circulating currents for proportional current sharing and voltage stability of isolated DC microgrid”, in Electric Power Systems Research, 180 (2020) 106-123.